Table 8-34 Port Forwarding parameters
Field Description
Application Name Select an application name from the list.
The default is Custom settings.
WAN Port Enter the WAN port range.
LAN Port Enter the LAN port range.
Internal Client Select a connected device from the list and enter the associated IP address.
Protocol Select the port forwarding protocol from the list:
• TCP
• UDP
• TCP/UDP
WAN connection list Select a WAN connection from the list.
Note: Only active devices are shown on this list.
3
Click Add.
Click Delete to delete a port forwarding configuration.
END OF STEPS
8.41 Configuring port triggering
1
Click Application→Port Triggering from the left pane. The Port Triggering page displays.
Figure 8-40 Port Triggering page
Configure a XS-2426X-A indoor ONT
Configuring the Application
Configuring port triggering
Nokia ONT
Review Review
December 2021
Issue 1 135
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA
To Next Page
Loading...
