2
Configure the following parameters:
Table 8-24 QoS Config parameters
Field Description
QoS Setting
Type Select a QoS service layer type from the list L2 Criteria or L3 Criteria.
Classification Criteria
Source MAC Enter the source MAC address.
Click Exclude to exclude the source MAC address.
Interface Select an interface from the list.
Classification Row
DSCP remark Enter the value for the DSCP mark (range: 0-63); valid only for L3 Criteria.
802.1p Remark Enter the value for the 802.1p (range: 0-7).
Forwarding Policy Enter the number for the forwarding policy (range: 1-7).
Additional fields for L3 Criteria
Protocol Select a protocol from the list, or click Exclude
Application Select an application from the list.
Source IP and Source IP
Mask
Enter the values for the source IP and IP mask, or clickExclude.
Destination IP and
Destination IP Mask
Enter the values for the destination IP and IP mask, or click Exclude.
Source Port and Source
Port Max
Enter the values for the source port and port max (highest port number) or click Exclude.
Destination Port and
Destination Port Max
Enter the values for the destination port and port max (highest port number), or clickExclude.
3
Click Add to add a QoS policy.
END OF STEPS
Configure a XS-2426X-A indoor ONT
Network configuration
Configuring QoS
Nokia ONT
Review Review
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA
December 2021
122 Issue 1
To Next Page
Loading...
