1
Place the indoor ONT unit on a flat surface, such as a desk or shelf.
Note: The XS-2426X-A cannot be stacked with another ONT or with other equipment.
The ONT mounting requirements are:
• allow a minimum 100 mm clearance above the top cover
• allow a minimum 50 mm clearance from the side vents
• do not place any heat source directly above the top cover or below the bottom cover
2
Review the connection locations, as shown in Figure 6-1, “XS-2426X-A ONT connections”
(p. 64)
.
3
Connect the Ethernet cables to the RJ-45 ports.
4
Route the POTS cable directly to the RJ-11 port as per local practices.
Figure 6-1 XS-2426X-A ONT connections
37135
WPS
WLAN
ON/OF
F
P
O
W
ER
USB
L
A
N1
L
A
N2
L
A
N3
10G
E
TEL2
TEL1
Ethernet
ports (4)
(RJ-45)
Wi-Fi
security/
on/off buttons
On/off
button
Power
USB
POTS
ports (2)
(RJ-11)
Install a XS-2426X-A indoor ONT
Procedure
Nokia ONT
Review Review
December 2021
Issue 1 65
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA
To Next Page
Loading...
