34
www.norcold.com
2118, 2118IM, 2118IMD Series
Remove / Replace the Refrigerator
The rear of the refrigerator has sharp cor-
ners. To prevent cuts or abrasions when
working on the refrigerator, be careful and
wear cut resistant gloves.
Remove the Refrigerator
1. Close the valve at the propane gas tanks(s) of the vehicle.
To avoid possible propane gas leaks, al-
ways use two (2) wrenches to loosen and
tighten the propane gas supply lines at the
refrigerator’s manual shut off valve.
2. Open the lower intake vent and remove the propane gas supply
line from the 3/8 inch male are tting of the refrigerator.
3. Unplug the AC power cord from the receptacle.
4. Remove the DC wiring from the battery or the converter of the
vehicle.
5. Put a mark on the DC wires so that you can put them back in
the correct location.
6. Remove the DC wires from the refrigerator.
7. Remove the screws which fasten the refrigerator to the oor.
8. Remove the door from the refrigerator.
9. Remove the screws which fasten the refrigerator to the wall.
Very heavy object. Do not attempt to re-
move without help. Unassisted attempts
will likely cause bodily injury, property
damage, or both.
10. Remove the refrigerator from the opening.
!
ATTENTION
!
ATTENTION
!
Replace the Refrigerator
Very heavy object. Do not attempt to
install without help. Unassisted attempts
will likely cause bodily injury, property
damage, or both.
1. Push the refrigerator completely into the enclosure.
Make sure the combustion seal is not
broken, is completely around the refrig-
erator mounting anges, and is between
the mounting anges and the wall of the
enclosure. If the combustion seal is not
complete, exhaust fumes can be pres-
ent in the living area of the vehicle. The
breathing of exhaust fumes can cause
dizziness, nausea, and in extreme cases,
death.
2. Remove the door from the refrigerator.
3. Put the screws through the mounting ange and into the wall.
4. Attach the door to the refrigerator.
5. Open the lower intake vent and put the screws through the
refrigerator into the oor.
To avoid possible propane gas leaks, al-
ways use two (2) wrenches to loosen and
tighten the propane gas supply lines at the
refrigerator’s manual shut off valve.
6. Attach the propane gas supply line to the 3/8 inch male are
tting of the refrigerator.
7. Open the valve of the propane gas tank(s) of the vehicle.
Do not allow the leak checking solution to
touch the electrical components. Many
liquids are electrically conductive and can
cause a shock hazard, electrical shorts,
and in some cases, re.
8. Using a leak checking solution, examine the gas supply line
connections for leaks. No leaks are allowed.
9. Connect the DC wires from the refrigerator.
10. Connect the DC wiring to the battery or the converter.
11. Push the AC power cord into the receptacle.
ATTENTION
!
ATTENTION
!
ATTENTION
!
ATTENTION
!
To Next Page
Loading...
