Nordson AltaBlueA4TP - Page 4

Table of Contents
ii
Part 1107600_03
 2014 Nordson Corporation
Installation 3-1.................................................
Quick‐Start 3‐1.................................................
Overview 3‐1..................................................
Additional Information 3‐2.....................................
Installation Tasks 3‐2.........................................
Experience of Installation Personnel 3‐2.........................
Installation Requirements 3‐4....................................
Clearances 3‐4..............................................
Electrical Power 3‐6..........................................
Electrical Enclosure Ventilation 3‐6.............................
Other Considerations 3‐6......................................
Unpacking the Melter 3‐7........................................
Customer‐Supplied Materials 3‐7...............................
Contents of the Installation Kit 3‐7..............................
Removing the Base Panels 3‐9...................................
Mounting the Melter 3‐10.........................................
Configuring the Electrical Service 3‐12..............................
Connecting Hoses and Guns 3‐14.................................
Setting Up the Melter 3‐16........................................
Quick Setup 3‐16..............................................
Operating Parameters 3‐19.....................................
Selecting Operating Parameters 3‐20..........................
Reading or Editing Operating Parameters 3‐20..................
Setpoint Temperature of the Tank, Hoses, and Guns 3‐25..........
Save and Restore Melter Settings 3‐27...........................
Review Parameter and Setpoint Temperature Changes 3‐28........
Setting Up the Motor Control 3‐30..................................
Installing Melter Inputs 3‐33.......................................
Installing Melter Outputs 3‐37.....................................
Setting Up Gear‐to‐Line Operation 3‐40.............................
Reinstalling the Base Panels 3‐44..................................
Installing Optional Equipment 3‐45.................................
Flushing the Melter 3‐45..........................................