Nordson AltaBlueA4TP - Page 5

Table of Contents
iii
Part 1107600_03
 2014 Nordson Corporation
Operation 4-1..................................................
Additional Information 4‐1........................................
More about Heated Components 4‐2...........................
Filling the Tank 4‐3..............................................
Starting the Melter 4‐4...........................................
Manually Adjusting the Pump Speed 4‐8...........................
Adjusting the Pressure Control Valve 4‐9..........................
Monitoring the Melter 4‐10........................................
Confirm that the Melter is Operating Correctly 4‐10.................
Monitor Component Temperatures 4‐12..........................
Monitor Melter Faults 4‐14......................................
How F1, F2, and F3 Faults are Handled 4‐16...................
How F4 Faults are Handled 4‐17..............................
Monitor Motor Control or Motor Drive Faults 4‐22..................
Monitor the Service Interval 4‐22................................
Adjusting Component Temperatures 4‐23...........................
Entering the Melter Password 4‐28.................................
Using Melter Function Keys 4‐29...................................
Heaters Key 4‐29.............................................
Master Pump Enable Key 4‐30..................................
Setup Key 4‐30...............................................
Seven‐Day Clock Key 4‐31.....................................
Standby Key 4‐32.............................................
Shutting Down the Melter 4‐33.....................................
Maintenance 5-1...............................................
Maintenance Schedule 5‐1......................................
Relieving System Pressure 5‐3...................................
Locking Out External Communications 5‐3.........................
Cleaning the Melter 5‐4..........................................
Replacing the Adhesive Filter 5‐6.................................
Cleaning the Tank 5‐8...........................................
Tightening the Pump Screws 5‐10.................................
Calibrating the Level Sensor 5‐12..................................
Troubleshooting 6-1............................................
Safety 6‐1......................................................
Melter Faults 6‐2...............................................
Motor Control Faults 6‐4.........................................
Motor Drive Faults 6‐5...........................................
Motor Drive Parameters 6‐8......................................
Changing a Motor Drive Parameter 6‐8..........................
Motor Drive Parameter Settings 6‐10.............................
Calibrating the Pump Speed Display 6‐16..........................
Pump Operational Status 6‐17.....................................
Using the Troubleshooting Flowchart 6‐20..........................
Troubleshooting Quick‐Checks 6‐21..............................
Returning the Melter Setup to Factory Settings 6‐21................
Identifying Electrical Components 6‐22...........................
AltaBlue Troubleshooting Flowchart 6‐27.........................