Installation
3-24
Part 1107600_03
2014 Nordson Corporation
To read or edit a parameter (contd)
You can exit the setup mode at any time by
pressing the Setup key.
Parameter numbers that are not applicable
are skipped when you scroll through the
operating parameter list in the left display.
When the right display is flashing, you can
quickly set the value of the current parameter
to it’s lowest possible value by simultaneously
pressing both of the right-display scroll keys.
While in the setup mode, if no key is pressed
for two minutes, the melter will return to the
automatic scan mode.
You can also use the right-display scroll keys
to enter or change a parameter’s value or
control option. After entering the parameter’s
number in the left display, press either of the
right-display scroll keys to change the value or
control option.
If password protection is enabled, the melter
will return to the password protected mode
whenever you exit the setup mode.
Appendix B, parameter 10
To Next Page
Loading...
