Operating Parameters
B-1
Part 1126931_01
2018 Nordson Corporation
Appendix B
Operating Parameters
Operating parameters are organized in this appendix according to the logical
groups listed in Table B‐1. For information about selecting and editing
operating parameters, refer to Section 3, Installation, Setting Up the Melter.
NOTE: Parameter numbers that are reserved or that are not used do not
appear in this appendix.
Table B-1 Parameter Groups
Group
Parameters Description
Standard 0 to 13 Frequently used parameters
Temperature
Control
20 to 29 Control heater function
Input Setup 30 to 33 Configure the inputs
Output Setup 40 to 42 Configure the outputs
Seven‐day
Clock
50 to 77 Configure the clock feature
PID Selection 80 to 91 Change preset PID settings
To Next Page
Loading...
