Melter Communications
C-8
Part 1126931_01
2018 Nordson Corporation
Upgrading or Restoring Melter Firmware (contd)
To upgrade or reload melter firmware
1. Connect your PC to the melter. Refer to Connecting the PC and the
Melter earlier in this guide.
2. Place the melter into the upgrade mode by switching the melter off and
then on again, and then immediately pressing and holding both the
Setup and left display Scroll key.
UPLOAd appears in the right display.
3. Double‐click the NCM icon on the Windows desktop.
The NCM dialog box appears.
4. Click Select.
The device dialog box appears.
5. Select your melter from the list, and then click Ok.
The Select COM Port dialog box appears.
6. Select the COM port you are using to connect to the melter, and then
click Ok.
The PC and melter establish communications and a picture of the melter
you selected appears in the device status area. The right side of the
status area indicates Connected.
7. Click Upgrade.
The Select Upgrade dialog box appears.
8. In the Available Upgrades list, select the firmware version you want to
upload to the melter, and then click Ok.
The upgrade warning message appears.
9. Click OK.
The Upgrade in Progress dialog box appears. The upgrade can take as
long as 12 minutes. When the upgrade is complete, the Success dialog
box appears and the melter restarts.
To Next Page
Loading...
