Glossary
10-5
Part 237478_03
E 2012 Nordson Corporation
An electronic circuit whose operation depends upon any combination of
optical, electrical or magnetic phenomena within a solid. Specifically
excluded are circuits that depend upon physical movement, as well as those
requiring either contact with or avoidance of other solids, liquids, gases or
plasmas.
A device whose electrical functions are performed by semiconductors or
otherwise completely static components such as resistors and capacitors.
The device may contain components that do not depend on electronic
conduction in a vacuum or gas.
In the Nordson context, a material used to desolve hot melt adhesive to
facilitate system cleaning.
A defect in adhesive application characterized by hair‐like fibers of adhesive
emanating from the trailing edge of the bead. Stringing may produce
continuous fibers attached to the nozzle. It is most often caused by the gun
temperature being too cold.
The material or product on which the adhesive is applied.
The amount of material that the tank can hold with the fluid level 25 mm (1
inch) from the top of the hopper or tank.
A product feature that helps keep large pieces of foreign material out of the
pump.
The volume that the tank can hold when it is filled. The displacement of the
pump is taken into account in this measurement.
That part of a temperature control system that detects the temperature and
feeds this information to the control device.
A product feature by which the system temperature may be automatically
reduced to a preset number of degrees.
A synthetic material which is solid at room temperature, becomes soft when
heated, and returns to solid form upon cooling.
See Pattern Control.
Operator interface.
Air free of oil.
A physical measurement of resistance to flow.
Solid State Circuitry
Solid State Device
Solvent
Stringing
Substrate
Tank Capacity
Tank Strainer
Tank Volume
Temperature Sensor
Temperature Setback
Thermoplastic Material
Timing Device
Touch Pad
Unlubricated Air
Viscosity
To Next Page
Loading...
