EasyManuals Logo

Nordson FP-200 User Manual

Nordson FP-200
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
Installation
3-6
Part 237478_03
E 2012 Nordson Corporation
Guidelines for Installing the Tool Balancer (contd)
NOTE: Before attaching the gun and hose to the tool balancer, make sure
that the weight is within the accepted load specification.
Adjust the balance upward or downward by modifying the cable tension
setting.
To increase cable tension, perform the following step:
a. Turn the ratcheting balance adjust clockwise.
To decrease cable tension, perform the following steps:
a. Turn the ratcheting balance adjust clockwise until the ratchet
release is free of the ratcheting mechanism.
b. Allow the ratcheting balance adjust to rotate counterclockwise in
increments of ¼ turn.
CAUTION! Hold the ratcheting balance adjust firmly when
decreasing cable tension. When the ratchet release is rotated free
of the ratcheting mechanism, the ratcheting balance adjust is
under spring tension and will quickly rotate counterclockwise if not
held firmly.
Replacing Air-Control-Kit FP-200 Guns
NOTE: This section applies only to customers who are replacing the version
of the FP‐200 gun that used an air control kit with a new FP‐200gun.
1. Disconnect the old gun electrically and hydraulically from the hose.
2. Disconnect the old gun's air lines.
3. Remove the old gun's trigger cable and one air line from the suspension
system.
4. Disconnect the air control kit.
5. Continue with the following procedures to install the new gun.

Table of Contents

Other manuals for Nordson FP-200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nordson FP-200 and is the answer not in the manual?

Nordson FP-200 Specifications

General IconGeneral
BrandNordson
ModelFP-200
CategoryPaint Sprayer
LanguageEnglish

Related product manuals