Nordson FP-200 - Installing the Mast and Pivoting Arm

Installation
3-4
Part 237478_03
E 2012 Nordson Corporation
Installing the Mast and Pivoting Arm
Use the following procedure and refer to Figure 3‐2 when installing the mast.
1. Assemble the floor stand with screws and nuts provided.
2. Make sure to slide the plastic cover over base flange assembly.
3. Insert the rod of the pivoting arm into the top hole in the mast.
B B
AA
View A-A
0.25
View B-B
0.50
2.50
3.00
0.25
2.50
3.00
5.00
4.00
4.00
5.00
3
5
6
4
2
1
Figure 3‐2 Suspension System Swing Arm,Floor Mount Mast with Dimensions
1. Pivoting arm
2. Pivoting arm rod
3. Top hole in the mast
4. Retaining plate (plastic)
5. Screws and nuts (provided)
6. Mounting base