Nordson FP-200 User Manual

Installation
3-1
Part 237478_03
E 2012 Nordson Corporation
Section 3
Installation
WARNING! Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Introduction
This section provides unpacking, safety, and installation information
necessary for installing the FP‐200 gun.
Unpacking the Gun
Exercise normal care to prevent equipment damage during unpacking.
The gun and module (either swirl or extrusion) are configured according to
each customer's particular sales order. If there is a discrepancy between the
sales order and the equipment received in the shipment, contact your
Nordson representative.
Inspecting the Gun
After unpacking the gun, make the following inspections:
1. Check for gun surface dents, scratches, corrosion, or other physical
damage. Contact your Nordson representative if there is any physical
damage.
2. Remove foreign material in the service block air and fluid ports.
3. Tighten any loose fasteners.

Nordson FP-200 Specifications

General

Brand	Nordson
Model	FP-200
Category	Paint Sprayer
Language	English