Installation
3-5
Part 237478_03
E 2012 Nordson Corporation
Guidelines for Installing the Tool Balancer
Use the following guidelines when preparing the tool balancer for installation.
CAUTION! Install the tool balancer correctly to prevent personal injury or
damage to the tool balancer or other equipment.
NOTE: Proper balance is accomplished when the gun can be raised or
lowered with equal effort, and it can maintain its position anywhere along the
rated cable travel.
CAUTION! Over‐increasing the tension could cause damage to the balancer
spring.
Figure 3‐3 Tool Balancer Components
1. Main hanger
2. Anchor safety support chain
3. Ratcheting balance adjust
4. Load hook
5. Ratchet release (pawl)
To Next Page
Loading...
