Installation
3-12
Part 237478_03
E 2012 Nordson Corporation
Connecting the Gun and Hose to the Pivoting Arm and Mast (contd)
2. Clamp the hose to the nylon hose hanger, located at the rear of the swing
arm.
a. Provide a smooth loop for the hose. There must be no sharp bends in
the hose.
b. Taking care that the hose is not twisted, make sure to hang it from the
stationary mount with the nylon strap.
NOTE: When positioning the hose in the stationary bracket, ensure that
the poly pneumatic line(s) are not pinched or crimped, restricting air flow.
3. Referring to Figure 3‐9, adjust the desired gun resting height from
working surface by sliding the hose through the straps. Once the desired
retracted height from the working surface has been obtained, ensure that
the straps are snug around the hydraulic hose.
4. Route all the remaining hose, the black poly pneumatic line(s) and the
trigger control cable to the applicator and air controller location. Do not
connect the hose hydraulically or electrically at this time.
To Next Page
Loading...
Need help?
General
