Table of Contents
ii
Part 237478_03
E 2012 Nordson Corporation
Installation 3‐1................................................
Introduction 3‐1.............................................
Unpacking the Gun 3‐1.......................................
Inspecting the Gun 3‐1.......................................
Items Needed 3‐2...........................................
Suspension Package 3‐3.....................................
Installing the Mast and Pivoting Arm 3‐4........................
Guidelines for Installing the Tool Balancer 3‐5...................
Replacing Air‐Control‐Kit FP‐200 Guns 3‐6......................
Connecting the Gun and Hose 3‐7.............................
Connecting the Gun to the Hose and Air Line 3‐8.................
Connecting the Gun and Hose to the Pivoting Arm and Mast 3‐11....
Installing the Auxiliary Guide Handle and Rotating the
Trigger Handle 3‐13...........................................
Auxiliary Guide Handle Installation 3‐13.......................
Trigger Handle Rotation 3‐13................................
Installing the Heat Shield 3‐14..................................
Connecting the Gun to the Air Supply 3‐14.......................
Connecting the Hose to the Applicator 3‐14......................
Relieving Hydraulic Pressure 3‐15..............................
Flushing the Gun 3‐18.........................................
Flushing all Modules Except Reduced Cavity 3‐18...............
Flushing Reduced Cavity Modules 3‐20........................
Operation 4‐1.................................................
Starting up and Operating the FP‐200 Gun 4‐1...................
Adjusting the FP‐200 Swirl Gun Adhesive Pattern 4‐3.............
Shutdown 4‐3............................................
Maintenance 5‐1..............................................
Introduction 5‐2.............................................
Daily Maintenance 5‐2.....................................
Weekly Maintenance 5‐2...................................
Semiannual Maintenance 5‐2...............................
Maintenance Procedures 5‐3...............................
Troubleshooting 6‐1...........................................
Overview 6‐2..................................................
Quick Check of Module Operation 6‐2............................
Troubleshooting Guide 6‐3.......................................
Diagnostic Operational Checks 6‐7...............................
Nozzle Operational Check 6‐7.................................
Service Block Pneumatic Operational Check 6‐8.................
Heater Check 6‐9............................................
RTD Check 6‐10.............................................
Thermostat Check 6‐11.......................................