Operation
4-2
Part 237478_03
E 2012 Nordson Corporation
Starting up and Operating the FP‐200 Gun (contd)
CAUTION: Hot! Risk of burns. Hot applicator parts, splashed hot melt
material, and hot gun surfaces can cause severe burns. Wear long‐sleeved,
heat‐protective clothing, safety goggles, and heat‐protective gloves.
CAUTION! Risk of burns. To prevent inadvertent discharge during startup,
leave the trigger safety in the locked position while performing startup
procedures.
CAUTION! Never point the gun at anyone. Trigger the gun only when
adhesive is to be applied to a substrate.
CAUTION: Do not swivel or trigger the gun while it is cold. This can damage
the gun or swivel fitting.
1. Ensure that the trigger safety is in the LOCKED position.
2. Prepare the applicator for normal operation by following the startup
procedures in the applicator product manual.
3. Place the trigger safety in the unlocked position.
4. Position the gun at the desired location above the substrate.
5. Dispense adhesive by triggering the gun.
6. Stop dispensing adhesive by releasing the trigger.
7. When not using the FP‐200 gun, place the trigger safety in the LOCKED
position.
To Next Page
Loading...
