Maintenance
5-5
Part 237478_03
E 2012 Nordson Corporation
6. Remove the nozzle from the cleaning fluid and clean it using a pin‐type
probe (extrusion nozzles only). The Nordson nozzle cleaning kit includes
the holder and a variety of probes.
Figure 5‐5 Cleaning an Extrusion Nozzle
7. Reinstall the nozzle and retaining nut. Torque the retaining nut to
20‐25in‐lb.
8. Restore the system to normal operation by following the startup
procedures in the applicator product manual.
To Next Page
Loading...
