iCare+ Operation Manual 10-8-1 p. 23
A total of 7 switches are available. One switch: (labeled “Cycle”) is used to select one of the 3 types of cycle to run:
Full cycle (Cleaning + Disinfection + Lubrication), partial cycle (Cleaning + Lubrication) or short cycle (lubrication
only).
The "ext-WO” button enables the user to select the type of handpieces: a handpiece without spray or external spray,
or by default with an inner spray.
4 switches enable to select/deselect the instruments to be processed and the volume of lubricant to be used.
The “Start” switch is used to start the programmed cycle or as an emergency stop.
Figure 19: Control Panel of the iCare+ device's Front panel
A: Cycle selection button A': Operating light indicators (LEDs) for cycle selected
B: Ext w-o (or Spray) button for selection of the model of the handpiece(s)
C: Instruments selection and Oil volume button (Short or Long mode)
D: Start-up button. This button can also be used to stop the unit during cycle (with a long press).
E: Cycle progress operating light indicators (LEDs)
F: Warning operating light indicators (LEDs) for consumables state and for drawer, air, door state
1, 2, 3, 4: Indicator of the type of instrument (if the indicator is lit: instrument with external spray or without spray)
To Next Page
Loading...
