iCare+ Operation Manual 10-8-1 p. 25
By default the Short cycle of oil is selected; press the button corresponding to the position where the instrument is
connected, once to select the Long cycle (large drop LED lit) and twice to deselect the instrument.
3.5.5. Selecting the type of instrument
In parallel, the user will be able to choose the type of instrument.
The iCare+ device is designed to enable the treatment of 2 models of dental rotary instruments:
Dental devices with only one drive channel
Dental devices with 2 channels: W/A + drive channels
All the different instruments that can be treated with iCare+ device are mentioned in the following table:
Contra-angle or handpiece with external spray or without spray
W/A +
DRIVE
CHANNELS
(2
CHANNELS)
Contra-angle or handpiece with internal spray
Table 1: List of different treatable instruments per model
Standard setting of iCare+ is designed for internal spray instruments. To make the selection for external or without
spray instrument, it is necessary to push simultaneously the “ext/WO button” and the button corresponding to the
position of the instrument without or external spray.
For example to change the model of instrument 2, the operator will have to press simultaneously the button "ext
W/O” and the button 2; see on Figure 21 below. The LED "ext W/O", near button 2, is now lit to inform the operator
that the instrument 2 is an instrument without spray or with external spray.
Button for
selection of
External/Without
spray instrument
To Next Page
Loading...
