iCare+ Operation Manual 10-8-1 p. 20
To connect a contra-angle or a hand piece on e-type connectors, in accordance with the ISO 3964 standard, start by
opening the door and connect the contra-angle on the E-type connector (see Figure 17). Finish this operation by
closing the door.
Place properly the contra-angle in the connector until you hear a “click”. In
this way, the contra-angle will be well maintained during the different
phases of the treatment.
3.4.3. Removing the instruments
For removing an air turbine, in accordance with the ISO 9168 standard, follow the description below:
Once the cycle has finished, you will hear a "BIP" sound and the green operating light indicator ("END" LED) will be
lit, start opening the door. After that, remove the turbine from the connection.
CAUTION:
Please make sure to remove any bur from the chuck
Make sure also to remove any support/holder for snap-on caps
If not the dirt and liquid inside the instrument could not come out
Figure 17: Connection of a contra-angle
Figure 18: iCare+ version 1 with 1 air turbine
and 3 E-type connectors
To Next Page
Loading...
