•
•
•
•
•
•
•
Airflow Requirements
ConnectX-7 adapter cards are offered with two airflow patterns: from the heatsink to the network
ports, and vice versa, as shown below.
Please refer to the Specifications section for airflow numbers for each specific card model.
Airflowfromthe heatsinkto the network ports Airflowfrom the network ports to the heatsink
Software Requirements
See System Requirementssection under the Introduction section.
Software Stacks - NVIDIA® OpenFabrics Enterprise Distribution for Linux (MLNX_OFED),
WinOF-2 for Windows, and VMware. See the Driver Installation section.
Safety Precautions
The adapter is being installed in a system that operates with voltages that can be lethal. Before
opening the case of the system, observe the following precautions to avoid injury and prevent
damage to system components.
Remove any metallic objects from your hands and wrists.
Make sure to use only insulated tools.
Verify that the system is powered off and is unplugged.
It is strongly recommended to use an ESD strap or other antistatic devices.
Pre-Installation Checklist
Unpack the ConnectX-7 Card; Unpack and remove the ConnectX-7 card. Check against the
package contents list that all the parts have been sent. Check the parts for visible damage
that may have occurred during shipping. Please note that the cards must be placed on an
antistatic surface. For package contents please refer toPackage Contents.
All cards in the system should be planned with the same airflow direction.
Please note that if the card is removed hastily from the antistatic bag, the plastic
ziplock may harm the EMI fingers on the networking connector. Carefully remove the
card from the antistatic bag to avoid damaging the EMI fingers.
To Next Page
Loading...
Need help?
General
