•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Added a new query to read thresholds and monitor the cable's
properties:
Temperature
Voltage
RX/TX powers
TX Bias
All
Added a new RAW format for printing the data of the cable’s pages
using the “--raw/--format raw” flags.
All
mstconfig Enabled mstconfig to work with a database that describes the meta
data of the TLVs configuration of fifth generation devices.
All
Added the following configuration TLVs to mstconfig:
MPFS
KEEP LINK UP
SW OFFLOAD CONF
All
mstreg Added support for PPTT, PPRT and PPAOS access registers in
switches.
All
mstflint Added support for viewing and changing OEMs’ device flash
parameters using an IB device when using mstflint.
All
Rev. 4.4.0
mstfwreset Added support for mstfwreset in PowerPC Linux
mstconfig Added the following new configurations:
Number of TCs
Number of VLs
Enable DCBX in CEE mode
Enable DCBX in IEEE mode
Allow the NIC to accept DCBX configuration from the
remote peer
Enable DCBX
Enable the internal LLDP client
Select which LLDP TLV will be generated by the NIC
All
General Added support for all tools to work when the MST driver is not
installed
Linux
mstcables Added support for dumping Mellanox cables EEPROM by mstdump/
mstdump tools
Linux
Windows
FreeBSD
Added a new tool (mstcables) that reads/writes Mellanox cable
registers and queries the cables info
Linux
Windows
FreeBSD
To Next Page
Loading...
Need help?
General