NXP Semiconductors PN544 C2 - Jewel;Topaz Reader; Jewel reader RF gate; NXP_JEWEL_RAW_CMD Command

NXP Semiconductors
UM191812
PN544 C2 User Manual
191812 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2010. All rights reserved.
User Manual Rev. 1.2 — 2010-06-16 110 of 172
9.10 Jewel/Topaz Reader
PN544 offers Jewel/Topaz reader functionality through the generic “Reader RF gates”
features of the ETSI HCI specification. This is done with the following proprietary gate:
Table 101. Jewel reader RF gate
Gate GID
Jewel reader RF gate ‘15’
Activation/Deactivation sequence are done using the generic events
“EVT_READER_REQUESTED”, “EVT_END_OPERATION”,
“EVT_TARGET_ACTIVATED” described in the “Reader RF gates” and “Reader Gates” of
ETSI HCI specifications. Then the activated Jewel/Topaz card can be accessed through
the following NXP proprietary command of the “Jewel reader RF gate”:
Table 102. NXP_JEWEL_RAW_CMD Command
Value Command Description
’23’
NXP_JEWEL_RAW_CMD
This command is used by the host to use Jewel native
command in a RAW Format
The NXP_JEWEL_RAW_CMD command has the following parameters:
Table 103. NXP_JEWEL_RAW_CMD Parameters
Description Length
Cmd 1
Data N
• Cmd describe the command type
• Data are parameters linked to the command
Table 104. Jewel Command Description For Classic Jewel Card (bit 4 of HRO = 0)
Value Description Data
0x00 ReadALL
Byte 1..2 : 0x00
Byte 3..6 : card ID