NXP Semiconductors
UM191812
PN544 C2 User Manual
191812 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2010. All rights reserved.
User Manual Rev. 1.2 — 2010-06-16 33 of 172
8. ETSI Host Controller Interface Compliancy
This chapter describes the functional interface provided by PN544. This API implements
the part of ETSI HCI specification [1] concerning the CLF.
It handles the
HCI Network management and defines how to control the CLF to act as
Reader or Card emulation.
This chapter describes the HCI commands and registries supported by PN544.
8.1 ETSI HCI Commands/ Events Supported
To have more details on commands/ events, please refer to the HCI specification [1].
Table 9. HCI All Gates
All Gates Status
ANY_SET_PARAMETER Supported on all pipes
ANY_GET_PARAMETER Supported on all pipes
ANY_OPEN_PIPE Supported on all pipes
ANY_CLOSE_PIPE Supported on all pipes
Table 10. HCI Gate Administration
Gate Administration Status
ADM_CREATE_PIPE Fully Supported (pipe routed or not)
ADM_NOTIFY_PIPE_CREATED Fully Supported (pipe routed)
ADM_DELETE_PIPE Fully Supported (pipe routed or not)
ADM_NOTIFY_PIPE_DELETED Fully Supported (pipe routed)
ADM_CLEAR_ALL_PIPE Fully Supported (pipe routed or not)
ADM_NOTIFY_ALL_PIPE_CLEARED Fully Supported (pipe routed)
Table 11. HCI Gate Link Manager Service
Gate Link Manager Service Status
No specific command for this gate
To Next Page
Loading...