NXP Semiconductors
UM191812
PN544 C2 User Manual
191812 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2010. All rights reserved.
User Manual Rev. 1.2 — 2010-06-16 148 of 172
-2- Set Debug_Interface to 0x01.
For further details on this signal, refer to [11].
To disa
ble this setup:
-1- Perform a Hardware Reset (VEN pin use).
-2- Set GPIO(s) direction to its default configuration (depending of application use).
To Next Page
Loading...