NXP Semiconductors PN544 C2 - Page 151

NXP Semiconductors
UM191812
PN544 C2 User Manual
191812 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2010. All rights reserved.
User Manual Rev. 1.2 — 2010-06-16 151 of 172
Address Name Comment Default
0x9EE9 0xFF
0x9EEA 0xFF
0x9C02
SWP_SyncID0 Reference value for checking the UICC identity during ACT SYNC_ID
verification sequence (SWP activation). Can be used to inhibit the UICC.
0x13
0x9C03
SWP_SyncID1
0x13
0x9EA2
UICC_AdminSessionId Registry entry related to SessionIdentity (Administration gate) of the UICC.
Can be used to force UICC to re-create its context.
0xFF
0x9EA3 0xFF
0x9EA4 0xFF
0x9EA5 0xFF
0x9EA6 0xFF
0x9EA7 0xFF
0x9EA8 0xFF
0x9EA9 0xFF
Table 131. SWP configuration register(*)
Address Name Comment Default
0xF841 SWIO_HighZ Register to set SWP SWIO line in HighZ mode.
-Bit 0 : If set to 1, the SWP Pad is in Power Down mode (HighZ).
-Bit 1-7 : RFU (keep unchanged)
0x10
(*) Register, volatile memory, valid until a power off/up sequence is performed or until
Hardware Reset (VEN pin use).