NXP Semiconductors PN544 C2 - Page 96

NXP Semiconductors
UM191812
PN544 C2 User Manual
191812 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2010. All rights reserved.
User Manual Rev. 1.2 — 2010-06-16 96 of 172
• Mode indicates the mode to switch to
Table 75. Mode Description
Value Description
0x00 ‘Wired mode’
0x01 ‘Default mode’
0x02 ‘Virtual mode’
0x03 ‘Off mode’
others RFU
Note: ‘Default mode’ is the mode set by NXP_SE_DEFAULTMODE registry.
Table 76. NFC-WI Registry
Id Name Access
Rights
Comment Length Default
‘01’
NXP_SE_DEFAULTMODE
RW
(EE)
Indicates the default mode of the SE connected
over NFC-WI.
0 -> Off mode
1 -> Virtual mode
Others values are RFU
1 0x00
‘05’ NXP_SE_EVENTS RW
(EE)
Defines which events have to be raised to the host
when occurred :
Bit Event
0 Start of transaction
1 End of transaction
2 .. 7 RFU
0 -> not to be raised
1 -> to be raised
1 0x00
Note: Some other NFC-WI settings are available in EEPROM (see ‘SE configuration’
c
hapter) for SE_Conf, WI_SE_SigoutSel, WI_SE_SigoutClkSel. NfcWi_SE_SigInDelay,
NfcWi_SE_TimeOut_H an
d NfcWi_SE_TimeOut_L.