Oki C3400N - Feeder Unit

43163501TH Rev.1 66 /
Oki Data CONFIDENTIAL
4.2.11 Feeder unit
(1) Open the top cover.
(2) Open the front cover. (See Subsection 4.2.4)
(3) Remove the Lever_Lock_Assembly 1.
(4) Remove the left side cover. (See Subsection 4.2.1)
(5) Remove the right side cover. (See subsection 4.2.2)
(6) Detach the plate shield front. (See Subsection 4.2.16)
(7) Remove a connector 3 connecting to the feeder unit 2 from the BLA board (main board).
(8) Take out four screws (silver) 4 to remove the feeder unit 2.
(9) Remove claws to remove the cover sensor 5.
(10) Remove the MIP board (front sensor board) 6.
Figure 4-2-11 Feeder unit
1
2
3
3
4
5
6
× 4
HOP
BLA-PCB
(Main circuit board PCB)
BLA-PCB (Main circuit board PCB)