Oki ES5432 - Page 115

- 115 -
5. Operating Management/ Specifications
•Hex Dump
Color Menu
System Configuration Menu
Item Factory
default
setting
Description
Hex Dump OFF Prints out the data received from the host computer in hex. To
finish printing, turn the machine off.
Item Factory default setting Description
Density Control Auto Select "Auto" or "Manual"
for adjusting density.
Adjust Density - Adjusting density is
performed right after this
menu is selected.
Color Tuning / Print Pattern - A test page is printed for
checking the adjusting value
to be entered for any other
C/M/Y/K Tuning menus.
Cyan Tuning Cyan Highlight 0 Adjust the value for
Highlight / Mid-tone / Dark of
each color within a range of
-3 to +3.
+ : Adjusted to be darker.
- : Adjusted to be lighter.
Cyan Mid-Tone 0
Cyan Dark 0
Magenta Tuning Magenta Highlight 0
Magenta Mid-Tone 0
Magenta Dark 0
Yellow Tuning Yellow Highlight 0
Yellow Mid-Tone 0
Yellow Dark 0
Black Tuning Black Highlight 0
Black Mid-Tone 0
Black Dark 0
Density Cyan 0 Adjust the total density of
each color within a range of
-3 to +3.
+ : Adjusted to be darker.
- : Adjusted to be lighter.
Magenta 0
Yellow 0
Black 0
Adjust Registration Color registration
adjustment is performed.
Ink Simulation OFF Sets the ink simulation. This
setting is enabled only for
PS language jobs.
UCR Low Adjusts the level of under
color removal.
CMY100% Density Disable Selects whether to use
halftone for C, M, Y 100%
density.
CMYK Conversion ON Selects whether to use
simple (quick) mode when
performing CMYK
Conversion.
This menu setting is
disabled if using the ink
simulation function.
Item Factory default setting Description
Personality Auto Selects the emulation mode. If auto is
set, the correct emulation is
automatically selected every time a
print job is received.
Alarm Release Manual If [Manual] is set, non-critical
warnings, such as requests for a
different paper size, can be cleared by
pressing [RESET]. If [Auto] is set, the
warnings are cleared when the print
job resumes.
Auto Continue OFF Sets whether the machine
automatically recovers from a memory
overflow.
Low Toner Continue Sets printer operation when Toner
Low is detected. In [Continue], the
printer can continue printing while
remaining ON-LINE. In [Stop], it
becomes OFF-LINE.
Error Report OFF Sets whether to print error details if
PostScript, PCL6, or XPS errors
occur.
Item Factory default setting Description