Oki ES5432 - Color of the Printed Image Is Not What You Expect; Solid Printing of CMY 100% Is too Light

- 99 -
4. Troubleshooting
Color of the printed image is not what you expect
Cause Solution Reference
The toner is low. If "Toner Low" or "Toner Empty.
Replace with new Toner Cartridge."
appears, replace the toner cartridge.
Replacing the Toner Cartridges
(User's Manual)
The setting of [Black Finish] is not
suitable for the application.
On the printer driver, select
[Composite Black (CMYK)] of [True
Black (K)] for [Black Finish].
Changing Black Finish
The color adjustment has been
modified.
Do color matching from the printer
driver.
Using Color Matching on Printer
Driver
The color balance is out of
adjustment.
Press the button on the operator
panel to select [Setting] > [Admin
Setup] > [Color Setup], and adjust
density or color balance.
Correcting Density Manually
Adjusting Color Balance
(Density)
Color registration is out of alignment. Open and close the output tray. Or,
press the button on the operator
panel to select [Setting] > [Admin
Setup] > [Color Setup], and then
[Adjust Registration].
Print Setup
Solid printing of CMY 100% is too light
Cause Solution Reference
[CMY100% Density] is set to
[Disable].
Press the button on the operator
panel to select [Setting] > [Admin
Setup] > [Color Setup] > [CMY100%
Density], and then select [Enable].
-