- 122 -
5. Operating Management/ Specifications
• Power Save
•Memory Setup
• Flash Memory Setup*
1
• Storage Maintenance Setup
• Language Maintenance Setup
• Job Cancel Setup
Allow All Reports To Print Disable Sets whether to allow printing reports with
personal information.
Near Life LED Enable Sets whether to light an LED if a near life
warning occurs.
Near Life Status Enable Sets whether to display a message if a near
life warning occurs.
Status Display Toner Gauge Specify display information in idle Display.
Paper Size: Display paper size of each tray.
Toner Gauge: Display toner gauge.
Panel Contrast 0 Sets the contrast of the display screen.
USB Memory Interface Enable If [Disable] is set, the print from USB Memory
function cannot be used.
Item Factory default setting Description
Power Save Time 1 minute Sets when to enter Power Save mode.
Sleep Time 15 minutes Sets when to enter Sleep mode.
Auto Power Off Time 4 hours Sets when to enter Auto Power Off.
Silent Mode ON Specifies a print preparation operation when
entering standby status from Sleep mode.
If [ON] is set: it is quiet as there is no print
preparation.
If [OFF] is set: there is a rotation noise of the
image to perform print preparation but you
can start first printing early.
ECO Mode*
1
ON If [ON] is set: Printing starts even before the
temperature of the fuser reaches the
prescribed degrees, if the job is small.
If [OFF] is set: Printing starts after the
temperature of the fuser reaches the
prescribed degrees.
Item Factory default setting Description
Receive Buffer Size Auto Sets the reception buffer size that local
interface secures.
Resource Save OFF Sets the resource save area.
Item Factory default
setting
Description
Item Factory default
setting
Description
Initialize Execute Initializes a flash memory.
This item is displayed when [Initial Lock] is
set to [Disable].
Format Partition PCL (NULL) Formats a partition.
Common (NULL)
PS (NULL)
Item Factory default setting Description
Check File System Execute Resolves any mismatch between actual
memory and displayed memory available in a
file system and performs administration data
(FAT information) recovery.
Initial Lock Enable Sets whether to give permission to change
settings associated with the memory
initialization.
Item Factory default setting Description
Select Language English Selects display language for the display
screen.
Initialize*
1
Execute Deletes downloaded message files.
Item Factory default setting Description
Cancel Key Behavior Short Sets the behavior when the (CANCEL)
button is pressed.
Short: Pressing the button for less than
2 seconds cancels the job.
Long: Pressing the button for 2 to 5 seconds
cancels the job.
Off: Pressing the (CANCEL) button does
not cancel the job.
Inquiry Display On Sets whether to display the confirmation
screen when cancelling the job.
Focus Position Yes Sets an option between "Yes" and "No" to be
highlighted on the confirmation screen
displayed when cancelling the job.
To Next Page
Loading...
