Oki MICROLINE ML521 - Combined Print Mode Command (Epson)

Chapter 4: Character Style Commands34
Character Pitch Settings for Calculated H
fwd
, L
fwd
Values
Hex Value Character Pitch
00 Command invalid
90 10 cpi
78 12 cpi
60 15 cpi
54 17 cpi
48 20 cpi
The setting made using the H
fwd
and L
fwd
parameters will automatically be overridden if the fa
parameter is set to 02 hexadecimal.
Parameter f
a
Parameter f
a
is used to engage proportional spacing.
f
a
= 02 hexadecimal (2 decimal): engage proportional spacing
f
a
= 00 hexadecimal (0 decimal):use character pitch set by parameters H
fwd
and L
fwd
.
Combined Print Mode Command (Epson)
⻬ ML320 E/I, ML321 E/I ⻬ ML320 Turbo, ML321 Turbo ⻬ ML520, ML521
⻬ ML390 Turbo, ML391 Turbo ⻬ ML590, ML591
Function ASCII Decimal Hexadecimal
Select Print Features ESC ! n 27 33 n 1B 21 n
This command lets you use any combination of the features listed in the table below. The value
of n can range from 0 to 255. To determine the value of n, add up the values for all the features
you wish to use. To turn off all these features and return to 10 cpi printing, substitute 0 for n.