Oki MICROLINE ML521 - Custom Character Set OnOff Commands for 24-Pin Printers (Epson); Load Custom Character Set into Upper ASCII Command for 24-Pin Printers (Epson)

Chapter 5: Custom Character Commands 51
Custom Character Set On/Off Command for 24-Pin Printers (Epson)
⻬ ML390 Turbo, ML391 Turbo ⻬ ML590, ML591
Function ASCII Dec Hex
Select Standard Character Set ESC % 0 27 37 0 1B 25 00
Select Custom Character Set ESC % 1 27 37 1 1B 25 01
To switch from the standard character set to the custom character set, use the ESC % 1
command.
To switch back to the standard character set, use the ESC % 0 command. Otherwise, the
custom character set will remain in the printer's memory until one of the following happens:
• you turn off the printer
• you reset the printer with the ESC @ command
• you overwrite them with new custom characters
• you use the ESC : NUL NUL NUL command to overwrite them with the standard character
set.
Load Custom Character Set into Upper ASCII Command for 24-Pin Printers (Epson)
⻬ ML390 Turbo, ML391 Turbo ⻬ ML590, ML591
Function ASCII Dec Hex
Select Custom Character Set ESC t 2 27 116 2 1B 74 02
This command loads the custom character set (decimal 0 to 127) into the upper ASCII range
(128 to 255).