OKIDATA ML395C - Operator Panel (TFOP)

Page: 144
Service Guide ML395/395C
Chapter A Board Diagrams
A.2.05 Operator Panel (TFOP)
Firmware
NONE
Fuses
NONE
Jumpers
NONE
Sensors
NONE
Switches
10 contact switches which control the following functions.
Select/Deselect (SEL)
Line Feed (LF)
Form Feed (FF)
Top of Form Set/ Park (TOF)
Quite Mode Select (QU)
Print Quality (PQ)
Character Pitch (CP)
Font Select (FSEL)
Micro Feed Up (UP)
Micro Feed Down (DOWN)
NOTE: The silk screening of QU and SEL on the operator panel board (TFOP) is incorrect. Their
positions are reversed.
Test Points
NONE