Page: 34
Service Guide ML395/395C
Chapter 3 Maintenance & Disassembly
3.2 DISASSEMBLY/ASSEMBLY PROCEDURES
General Information
This section contains the printer disassembly procedures. Only the removal procedures are explained
here. Reverse the procedure for the installation.
At the bottom of each procedure is a listing of the parts covered in that procedure. The Okidata part
number, item description, comment (RSPL, Option, Consumable) and cross-reference to Appendix B is
provided for each part. Items included in the Recommended Spare Parts List are indicated by the acronym
RSPL. N/A will appear where a part number is not available.
Part Item Comment Appendix B Number Description Reference
This Service Handbook lists the disassembly procedures for major components of the unit.
Okidata DOES NOT recommend disassembling a unit which is operating normally. If you decide to
perform disassembly during this training, Okidata recommends that you perform
only
the disassembly
procedures for RSPL items. All other procedures are provided to assist you in identifying parts. It is not
likely that you will perform these procedures while servicing the unit.
Be sure to read all notes, cautions, and warnings, as they contain important information regarding
disassembly / assembly.
Microline 395C-Plus Only (Color Version)
3.2.24
Ribbon Shift Arm and Shift Arm Spring
3.2.25 Roller Lever
3.2.26 Ribbon Guide
3.2.27 Bail Open Cam and Bail Open Gear
3.2.28 Ribbon Shift Cam and Ribbon Shift Gear
3.2.29 Ribbon Shift Cam Lever Assembly
Optional Bottom Push Tractor Unit (BPTU)
3.2.30 Printer Unit
3.2.31 BTFD PCB
3.2.32 Tension Spring
3.2.33 Sheet Guide
3.2.34 Bottom Cover
To Next Page
Loading...
