2-2
Okuma America Corporation
DOCUMENTDOCUMENT
DOCUMENTDOCUMENT
DOCUMENT
AA
AA
A
TIONTION
TIONTION
TION
Rev. 1-16-01
SPECIAL FUNCTIONS Manuals
These manuals are labeled #1,2,3,or 4. These manuals contain information pertaining to the
operation, parameter settings, and alarms associated with “special functions” on the machine.
The following is a list of some of the topics found in these manuals:
ELECTRICAL SCHEMATICS
These are the electrical diagrams for the machine. There is a standard set of schematics that
pertain to the standard machine. If the machine has special options, there will be a separate set
of schematics that will accompany the machine.
ALARM & ERROR LIST
This is the alarm book which contains most of the alarms that can occur on the machine. Some
special alarms can be found in the Special Functions manuals.
PROGRAMMING
This manual contains information pertaining to the programming functions of the machine.
DRIVE UNITS
This manual has information pertaining to the BL-IID,VACII, and VACIII.
PARTS Book
This manual contains layouts of the parts on the machine.
The rest of this section provides a topic directory. It is intended as a reference guide when
looking for certain information about an Okuma CNC machine. Some manuals are specific to a
certain application or a certain machine and might not be mentioned here. For example, there is
a manual for first time users of MC-V, MC-H, and MCR-B type machining centers that is
labeled OPERATION GUIDE.
To Next Page
Loading...