Olimpia splendid ARYAL S2 E - Common Issues; Optimal Operation; Safety Precautions; Troubleshooting

ENGLISH
EN - 10
4.3 - OPTIMAL OPERATION
To achieve optimal performance, please note the following:
• Adjust the direction of the air ow so that it is not blowing directly on people.
• Adjust the temperature to achieve the highest possible level of comfort. Do not adjust the unit to excessive
temperature levels.
• Close doors and windows in COOL mode or HEAT mode.
• Use the TIMER ON button on the remote controller to select a time you want to start your air conditioner.
• Do not place any object near the air inlet or air outlet, as the efciency of the air conditioner may be re-
duced and the air conditioner may stop running.
• Clean the air lter periodically, otherwise cooling or heating performance may be reduced.
• Do not operate unit with horizontal louvre in closed position.
When the air conditioner is to be used again:
• Use a dry cloth to wipe off the dust accumulated on the rear air intake grille in order to avoid the dust
being dispersed from the indoor unit.
• Check that the wiring is not broken off or disconnected.
• Check that the air lter is installed.
• Check if the air outlet or inlet is blocked after the air conditioner has not been used for a long time.
5 - TROUBLESHOOTING
5.1 - SAFETY PRECAUTIONS
If one of the following conditions occurs, switch o󰀨 and promptly disconnect the appliance.
• The power cord is damaged or heats up in an abnormal manner.
• You smell a burning odour.
• The unit emits loud or abnormal sounds.
• A power fuse blows or the circuit breaker frequently trips.
• Water or other objects fall inside the appliance.
INTHEPRESENCEOFTHESECONDITIONS,DONOTTRYTOSOLVETHEANOMALYBYYOUR-
SELF.PROMPTLYCONTACTARETAILERORANAUTHORIZEDASSISTANCECENTRE!
5.2 - COMMON ISSUES
The following problems are not a malfunction and in most situations will not require repairs.
Malfunctioning Cause What must be done?
The unit will not start. Current failure Wait for the current to be restored.
The unit is disconnected from the
current.
Check that the plug is inserted in the
wall socket.
A fuse has blown. Replace the fuse.
The remote control batteries may be
discharged.
Replace the batteries.
The compressor 3 minute protection
has activated.
Wait.