5-25
Operation on the Machine > Copying
Program
By registering sets of frequently used functions as a single program, you can simply select the program number as
needed to recall those functions. You can also name the programs for easy identification when recalling.
Registering Program
Use the procedure below to register a program.
1
Configure the settings of the functions.
Configure the settings of the functions you want to register in a program.
For the settings of functions, refer to Using Various Functions
on page 5-10.
2
Register the program.
1 Press the [Program] key.
2 Press the [▲] or [▼] key to select a program number (01 to 04) to register, and press the
[OK] key.
3 Press the [▲] or [▼] key to select [Add], and press the [OK] key.
• Only copying functions can be registered and recalled as programs.
• Up to 4 programs can be registered.
• Unregistered program numbers are displayed with [----------------].
• If you select a program number already registered, the currently registered function
s
ca
n be replaced with a new set of functions.
Select program
----------------
To Next Page
Loading...
Need help?
General
