Olympus BH2 Series - Page 36

e) Assemble Pinion Holder AB023600 in
position. (See Fig. 4-12.)
NOTE:
Take care not to disturb the Ball arrange-
ment.
f)
Drop the Balls in the direction
(C), similar
to steps
b) and c) above. (See Fig. 4-1 2.)
g) Tighten Nut AA782800 to Pinion ZJ-
I 1 ,25856400 856400 to eliminate thrust play
Fig. 4-12
A5059400
4-2-2
Assemble Tension Adjusting Knob
AB059400
\
with Pinion Mount AB023600.
Fig. 4-13
(See Fig. 4-1 3.)
NOTE:
Apply Grease OT2006 to the thread surface.
Assemble Spring
AA783800 and Washer
AA783700 in position. (See Fig. 4-1 3.)
NOTE:
Apply Grease OT2006 to contact surfaces.