Olympus BH2 Series - Page 37

4-2-4 Assemble the Pinion Mount Unit with the
Arm by tightening two Screws ACU3xSSA.
I A(:! r:{x!,sn
(See Fig. 4-1 4.)
NOTE:
Cement the Screws with Adhesive OT113T.
Fig. 4-74
Fig. 4-15
-
4-2-5 Adjust Pinion ZJ856400 as follows:
a) While turning Pinion ZS8.56400 by hand
adjust tightness condition of Nut AA-
782800
782800 until the Pinion is frt?c! from
uneven rotation or thrust play.
(See Fig. 4-1 5.1
NOTE:
Torque required to turn the Pinion;
Approx. 5 g (rotatable very lightly)
~~02360d
Fig. 4-16
b) For preventing Nut AA7.82.800 from
loosening, apply Adhesiua OT1027 at
three points on the threads of the Nut
AA782800 and Pinion ZJ856400.
(See Fig. 4- t 6.)
4-2-6
Fit Ring AA784100 attached to Cock Knob
ZJ808500 into Outer Ring AA784000 in the
following manner:
a) Carefully wipe Ring AA784100 until it is
free from grease or contaminant.
6) Also clean the inside of Outer Ring
AA784000 into which Ring AA784100
is to be fitted. (See Fig. 4-1 7.)
Fig. 4-17