Olympus BH2 Series - Page 38

b 4-2-7 Assemble Lock Knob AA785200 in position.
For this purpose, apply a thin coat of Grease
0162D06 to the thread and turn the Lock
AB 785200 ----*
Knob clockwise as far as it will go.
[See Fig. 4-18,)
I
4-2-8 Assemble Stopper AA001500 in position,
(See Fig. 4-18.)
-
AAOll I '>llt~
Fig. 4-1 8
4-2-9 Assemble Gear Mount AA782900 as follows:
a) Assemble Shaft AB0238QO with Gear
Mount AA782900 by threading shaft
into mount.
NOTE :
Fig, 4-19
Apply Adhesive OT1028 IAraFdite) to
the thread.
b) Assemble Gear Units ZA078200, ZJ-
078300, 25808800 and Plate AA783000
by tightening Screw 3PVK2.6x5SA and
two Screws S K2.6x5SA.
(See Fig. 4-1 9.)
NOTE:
Apply Grease OT2012 to the shaft of
each gear unit.
4-2-10 Assemble Coarse Adjustment KnobAB059000
together with three Washers AA800200 by
tightening three Screws 3PU K2.6x5SA.
4-2-1 1 l nsert Shaft A6023800 of the Coarse Adjust-
ment Knob (Fig. 4-19) from the right side
into Pinion 25856400 which is attached to
the Microscope Stand.
(See Fig. 4-20.)
4-2-12 Hook Screw AA146300 located on Ring
I
I I
I,
AA784100 into the circular portion at theend
of Spring AA784200. {See Fig. 4-20.)
rf
I- -
1
bU
u