Olympus BH2 Series - Page 39

4-2-1 3 Assemble Fine Drive Shaft Mount AA872250
as follows:
a) Apply Adhesive OTl 126 to the thread of
Screw AA146300 and screw it into Fine
Drive Shaft Mount.
b) After applying Grease OT2008 to Washer
AA872300, it in position,
c) Temporarily assemble twoscrews ACU3x
6SA to such a degree that they do not
protrude inside Fine Drive Shaft Mount
AA872200.
{See Fig. 14-21,)
Fig. 4-21
-- "-2-14 Place Fine Drive Shaft Mount AA872200 in
position as follows:
a) Fit Screw AA146300 located on Fine
Drive
Shaft Mount AA782200 into the
circular portion at the other end of Spring
AA784200 (as shown in Fig, 4-20).
4
While depressing the Fine Drive Shaft
I
I
I
Mount lightly toward the Microscope
Stand, turn it one rotation clockwise.
Fig. 4-22
Screw AA146300 on AA784100
(See Fig. 4-22.)
Then the two Screws AA146300 are
brought into contact with each other.
While :keeping Fine Drive Shaft Mount AA-
872200 a little apart from the M icroscape
Stand, move Screw AA'146300 over the
other screws. (These steps are illustrated
as A + B + C in Fig, 4-23.)
After one screw rotated over the other,
depress the Fine Drive Shaft Mount
lightly anto the Microscope Stand once
again. (See Fig. 4-23.)
Screw AA146300 on AA872200
Fig. 4-23