Olympus EVOLT E-300 - If an Error Code Is Displayed

153
9
Printing
Direct printing (PictBridge)
If an error code is displayed
● If an error code is displayed during direct printing setting or printing, see the
following table.
● For more details on solutions, refer to the printer’s instruction manual.
● If other codes are displayed, refer to “Error codes” (P. 174).
Monitor indication
NO CONNECTION
NO PAPER
NO INK
JAMMED
SETTINGS CHANGED
PRINT ERROR
CANNOT PRINT
Corrective action
Disconnect the camera and
connect it again correctly.
Load some paper in the printer.
Replace the ink cartridge in the
printer.
Remove the jammed paper.
Do not manipulate the printer
while making settings on the
camera.
Turn off camera and printer.
Check the printer and remedy
any problems before turning the
power on again.
Use a personal computer to
print.
Possible cause
The camera is not connected
to the printer correctly.
There is no paper in the
printer.
The printer has run out of ink.
The paper is jammed.
The printer’s paper cassette
has been removed or the
printer has been manipulated
while making settings on the
camera.
There is a problem with the
printer and/or camera.
Pictures recorded on other
cameras may not be printed
on this camera.
09E-300EN-P137 04.10.22 11:34 AM Page 153