Olympus MX63 - Page 120

To Previous Page

AX8974 02

Issued in May

, 2019

Distributed by

Manufactured by

Shinjuku Monolith, 2-3-1 Nishi-Shinjuku, Shinjuku-ku, Tokyo 163-0914, Japan

www.olympus-global.com

Main Page

Table of Contents3
Introduction7
Safety Precautions8
Nomenclature of Units19
List of Combinable Units24
Observation Procedures28
Reflected Light Brightfield/Darkfield Observation Procedures28
Main Switch30
Selecting the Observation Method (BF/DF)31
Selecting between the Eyepiece Light Path and the Camera Light Path32
Placing a Sample33
Moving the Stage33
Selecting the Objective34
Focusing35
Adjusting the Tension of the Coarse Focusing Knob35
Attaching/Detaching the Fine Focusing Knob35
Using the Pre-Focusing Lever36
Using the Focus Aid (MX-FA)37
Adjusting the Brightness38
When the LED Lamp Housing Is Combined38
When the Mercury Lamp Housing Is Combined38
When the Halogen Lamp Housing Is Combined38
When the Light Source Is Combined39
Using the LIM/SET Switch39
Adjusting the Observation Tube41
Adjusting the Interpupillary Distance41
Adjusting the Diopter41
Using the Eye Shades43
Adjusting the Tilt43
Adjusting the Aperture Diaphragm44
Using the Filter for Reflected Light Illumination45
Setting the Glare Prevention46
Observation Using the Mercury Burner47
Using the Oil Immersion Objective48
Image Acquisition49
Image Acquisition Diagram49
Observation Methods50
Transmitted Light Brightfield Observation Procedures50
Notes for Observation52
Adjusting the Transmitted Light Illumination52
Using the Field Diaphragm for Transmitted Light Illumination53
Using the Aperture Diaphragm for Transmitted Light Illumination54
Using the Filters for Transmitted Light Illumination55
Reflected Light Differential Interference Contrast (DIC) Observation Procedures56
Setting the Analyzer (When Using U-MDICAF3)57
Setting the DIC Slider58
Adjusting the Prism of the DIC Slider59
Reflected Light Simple Polarization Observation Procedures60
Reflected Light Fluorescence Observation Procedures61
Reflected Light IR (Infrared) Observation Procedures62
Reflected Light Simultaneous Observation for BF/DF Observation Procedures63
Inserting the MIX Slider for Reflected Light Observation64
Turning on the Illumination of the MIX Slider for Reflected Light Observation64
Adjusting the Illumination Brightness65
Selecting the Illumination Pattern66
Transmitted Light Simple Polarization Observation Procedures67
Setting the Analyzer and the Polarizer for Transmitted Light Illumination68
Replacement of Optical Parts69
Removing and Attaching the Eyepiece69
Replacing the Objective71
Replacing the Halogen Bulb74
Replacing the Mercury Burner76
Replacing the Filter81
Troubleshooting82
Specifications88
Optical Performance List <<UIS2 Series90
Assembly94
Assembly Diagram94
Assembly Procedures95
Attaching the Stage95
Attaching the Holders96
Attaching the Objective97
Attaching the Revolving Nosepiece97
Attaching the MIX Slider / DIC Slider for Reflected Light Observation97
Attaching the Observation Tube97
Attaching the Eyepiece97
Attaching the Light Source for Reflected Light Illumination98
Attaching the Breath Shield MX-BSH-ESD-2101
Connecting the Cables102
Setting the DIP Switch / AS.PRESET Switch104
Connecting the Power Cord107
Use of the Adjuster108
Seismic Protection108
Centering of the Aperture Diaphragm of Reflected Light Illumination109
Connection with PC110
Connecting the Interface Cable110
Start Procedures /Exit Procedures110
Maintenance Parts111
Preventive Inspection Sheet for Illumination Devices112
Proper Selection of the Power Supply Cord113
Appendix: Units Attached by Olympus115
Transmitted Light Illumination Unit (MX-TILLA/MX-TILLB)115
Setting the OP Light Path116
Attaching the Reflected Light Filter (26ND0.5)117
Attaching the Focus Aid (MX-FA)118

Olympus MX63 - Page 120

Table of Contents

Related product manuals