Olympus MX63 - Page 40

3434
Procedure to replay the brightness
Press the LIM switch
a
to set the "Replay" mode. (LIM switch
a
is ON.)
When you select the desired objective or the observation method, the
stored brightness is set automatically.
1
2
Restoring the stored brightness (LIM function)
to the factory default setting
Set the main switch of the microscope frame to (OFF).
Set the main switch of the microscope frame to
(ON) while pressing
both the LIM switch
a
and the SET switch
b
. Keep pressing the
LIM switch
a
and the SET switch
b
. The buzzer is heard three
times after 5 seconds, and the stored brightness returns to the factory
default setting.
· If you release the LIM switch and the SET switch within 5
seconds, the stored brightness (LIM function) does not return to
the factory default setting and the microscope starts normally.
· The buzzer sound can be set to silent by setting the DIP
switches. For setting procedures, see “Setting the DIP switch /
AS.PRESET switch" (P.98).
Set the main switch of the microscope frame to
(OFF).
1
2
TIP
3
a
a
b