81
MX63/MX63L
81
Repair request
If you cannot solve the problems even though taking actions described in Troubleshooting, please contact Olympus
for assistance. At that time, please tell them the following information as well.
· Product name and abbreviation (Example: Stage MX-SIC8R)
· Product number
· Problem
Display Problem Cause Remedy Page
7. Error indications by lighting and blinking of buttons
Front panel
2
1
3
4
“1" and "2" blink. g) Both two objective
selection buttons keep
blinking.
The DIP switch is not set
properly.
Set the DIP switch properly.
98
The objective interferes with
the sample or the stage.
Make sure that the objective
does not interfere the sample or
stage, and turn OFF the power
supplies of the microscope and
turn ON again.
—
The connection between
the revolving nosepiece
and the microscope frame
is disconnected.
Attach the revolving nosepiece
again properly.
65
The revolving nosepiece is
damaged.
Contact Olympus.
—
“1" to “4" are OFF. h) The buttons from “1" to
“4" keep blinking.
The hand switch (BX3M-HS)
or the hand switch for
exposure(U-HSEXP) is
unpluged after turning
ON the main switch of
microscope.
Set the main switch to
(OFF)
and connect the cords securely.
96
To Next Page
Loading...
