Chapter 2 Instrument Nomenclature
15
VISERA XENON LIGHT SOURCE CLV-S40
4. Output connector
The connector transmits light to the connected endoscope or light guide
cable.
5. Standby mode indicator
The indicator lights when the standby mode is selected.
6. AUTO/MANUAL brightness selector
Press to select AUTO or MANUAL brightness control.
7. MANUAL indicator
The indicator lights when the MANUAL brightness control is selected.
8. AUTO indicator
The indicator lights when the AUTO brightness control is selected.
9. Brightness control indicator
The indicator lights when the brightness control switches are available.
10. Brightness control switches
Press to set the video brightness level (in AUTO mode), or to adjust the light
level (in MANUAL mode).
11. Emergency lamp indicator
The indicator lights when the emergency lamp (halogen) is in use and blinks
when the emergency lamp switch lever is left in an intermediate position or
the emergency lamp is malfunctioning.
12. Brightness level indicator
These indicators display the current brightness level.
13. Intensity mode selector
Press to switch between the high intensity mode and normal intensity mode
(when using an endoscope compatible with the high intensity mode).
14. High intensity mode indicator
The indicator lights when high intensity mode is selected.
15. Lamp life meter
The meter indicates the approximate number of hours that the main lamp
(xenon)has been used.
16. Standby switch
Press to temporarily deactivate the illumination light.
Press again to exit from the standby mode and reactivate the illumination
light.
17. Emergency lamp switch lever
When the switch lever is set to the “EMERGENCY LAMP” position, the
emergency lamp (halogen) will turn ON. If the lever is set at an intermediate
position, neither the main lamp (xenon) nor the emergency lamp (halogen)
will turn ON. Be sure to set the switch lever to either the “MAIN LAMP” or
“EMERGENCY LAMP” position.
To Next Page
Loading...
