Olympus VISERA CLV-S40 - Chapter 4 Inspection Procedures; Pre-Use Inspection Warning; Powering On the Light Source

Chapter 4 Inspection
33
VISERA XENON LIGHT SOURCE CLV-S40
Chapter 4 Inspection
Before each use, inspect this instrument as instructed below.
Inspect other equipment to be used with this instrument as
instructed in their respective instruction manuals. Should the
slightest irregularity be suspected, do not use the instrument
and see Chapter 8, “Troubleshooting”. If the irregularity is still
suspected after consulting Chapter 8, contact Olympus.
Damage or irregularity may compromise the patient’s or
user’s safety and may result in more severe equipment
damage.
According to the “System chart” in the Appendix, prepare this instrument and
other equipment that are used with this instrument for the particular case. Refer
to the respective instruction manual for each piece of equipment.
4.1 Turn the power ON
Confirm that the main lamp (xenon) is mounted securely.
Turn the light source ON and confirm that power is being supplied to the unit by
observing the following conditions (see Figure 4.1):
• The green power switch indicator and the green indicators on the front
panel are illuminated.
• The cooling fan motor starts operating.
Figure 4.1
Indicators