Olympus VISERA CLV-S40 - Connecting to AC Power Supply

Chapter 3 Installation and Connection
31
VISERA XENON LIGHT SOURCE CLV-S40
3.4 Connection to an AC mains power supply
Connect the power cord directly to a wall mains outlet. If the
light source is not properly grounded, electric shock and/or
fire can result.
• Do not allow the power cord to become wet. A wet power
cord may cause electrical shock.
• Make sure that the wall mains outlet to which you connect the
light source has more capacity than the total power
consumption of all connected equipment (including the light
source). If the capacity is inadequate, fire can result or the
circuit breaker may trip and turn OFF the light source and all
other instruments.
• Do not bend, pull or twist the power cord. Electrical shock,
equipment damage or fire can result.
• Secure the power cord so that it will not be accidentally
disconnected during the procedure. The endoscopic image
will disappear if the power cord is disconnected during use.
1. Make sure that the power switch is OFF. The surface of the power switch
should be almost flush with the front panel surface (see Figure 3.17).
Figure 3.17
Power switch
Power switch
OFF ON